Plan your installation

When planning your eMat Pro layout ensure you cover as much of your free floor area as possible. Choose the closest size of eMat Pro possible, but always rounding down, to the nearest size.

Step One

Select the type of eMat Pro you require. For timber based floors use 100 Watts per m2, for concrete based floors use 150 Watts per m2.

If your floor consists of two types of construction, e.g. one half has a timber based floor and one half has a concrete based floor, each area should be controlled by its dedicated eStat.

Step Two

Select your required eMats to cover your free floor area. If your area is greater than 12 m2 use a combination of eMats.

Alternatively select one of our pre-packaged eMat Pro & eStat kits covering up to 22 m2 for timber based floors and 21 m2 for concrete based floors.

Step Three

Finally select your eStat controller.
A single controller can be used for up to 37 m2 of eMat Pro 100 W and 23 m2 of eMat Pro 100 W.

eMat Installation plan using one mat

eMat Installation plan using two mats

Depending on which type of floor you are building, you have the choice between eMat Pro in 100 or 150 W/m²